Varad Scanners® - Scanners® Styles: VS400, VS4000, VS500 Bedienungsanleitung PDF herunterladen

Whenever SCANNERS™ is active, press the "pattern select" button once to select the next pattern. There are 5 patterns to choose from. The selected

pattern will remain as long as power is not disrupted to the Red and Black wires.

Changing Patterns

Whenever SCANNERS™ is active, hold down the "pattern select" button for 3 seconds or more to either speed-up or slow-down the scanning motion.

This speed change will change the speed for all patterns.

Changing Speed of Scanning Motion.

Find Suitable location for installation of the Scanner on door or dashboard then clean surface with rubbing alcohol to remove oils. Remove both end

caps using small screw flat screwdriver. You can mount the Scanner using the 2 provided screws or double sided tape. Connect wires as shown in

diagram below.

Mounting the Scanner

1: Scanner does not remember pattern!

Trouble Shooting - frequently asked questions!

Memory loss will occur whenever the positive wire loses contact with the battery for a moment.

This can occure if the positive wire is attached to the wrong contact on the fuse box or some

other location in the vehicle. Try to connect directly to a line that goes directly to the battery

positive.

2: Scanner does not work when the alarm is turned on!

If you want the scanner to activate when the alarm is turned on you must connect the yellow

wire to the ground output (ignition kill) of your alarm system. DO NOT CONNECT TO THE

LED OUTPUT!. the LED output wire only provides 2-3 volts flashing and is not enough to

power the scanner. Refer to your alarm installation manual or ask your local dealer for the

correct ground output wire.

Scanner will activate when engine is turned off.

Installation without alarm system.

Patent Pending

Black

Yellow

Red

Battery Negative or Chassis ground.

Battery Positive (constant)

Ignition - Ground when engine is off (fuse box, ie.

Radio Fuse).

(Activates scanner when grounded.)

Scanner will activate when you arm your alarm.

Installation with alarm system.

Black

Yellow

Red

Battery Negative or Chassis ground.

Battery Positive (constant)

Alarm system accessory output or ground output.

(Activates scanner when grounded.)

SCANNERS are designed for installation

in all automobiles equipped with or

without an alarm system.

These instructions apply to All of the Following LED SCANNERS MOdels:

VS400P, VS400B, VS400WH, VS400AQ, VS400PU, VS5000, VS5000B, VS5000PU

VS4000, VS4000B, VS4000PU

VS4000, VS4000B, VS4000PU 1

Inhaltsverzeichnis

Seite 1 - VS4000, VS4000B, VS4000PU

Whenever SCANNERS™ is active, press the "pattern select" button once to select the next pattern. There are 5 patterns to choose from. The se

Kommentare zu diesen Handbüchern

Keine Kommentare

Varad Scanners® - Scanners® Styles: VS400, VS4000, VS500 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Für das Auto Varad Scanners® - Scanners® Styles: VS400, VS4000, VS500 herunter. Varad Scanners® - Scanners® Styles: VS400, VS4000, VS5000 User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Für das Auto Varad Scanners® - Scanners® Styles: VS400, VS4000, VS500